Corrosion Coatings
Rustgrip
RUST GRIP® is a tough, one-part, moisture-cure polyurethane coating that absorbs atmospheric moisture to cure. RUST GRIP® is loaded with a metallic pigment for strength and is also resistant to chemical solvents and acid splash. Upon curing, RUST GRIP® provides a protective coating film of superior adhesion and flexibility, and is resistant to abrasion and impact. RUST GRIP® can be used as a primer or as a one-coating system. It is patented to encapsulate lead- based paints and other toxic materials, including asbestos. RUST GRIP® can be applied over pressure- washed, completely dry flash rust and firmly bonded commercial paints. In most cases, a white or near- white blasting is not required. A light to medium surface rust is preferred as the profile. Rustgrip does not require UHP water-jetting or sandblasting to new or near new metal ( No SP5 0r Sp10 required) for surface preparation.
Moist Metalgrip
Moist Metagrip is a two-part epoxy coating system that has been specifically designed with specific additives to promote adhesion when used on metal. Moist Metalgrip was designed to be applied to metal surfaces that cannot be dry enough to use Rustgrip. It can be used directly on wet or damp metal surfaces and maintain excellent adhesion to prevent further surface corrosion. It is water repelling epoxy for use under water or in areas where constant splashing or condensation is a problem. It is resistant to chemicals and solvents and is designed to be applied directly to concrete ,masonry and wood.
Rustgrip E
RUST GRIP-E is a two-part epoxy coating system that has been designed with specific additives to promote adhesion when used on metal, and contains metal pigment to strengthen the coating and retard chalking. RUST GRIP-E was developed to be applied to metal surfaces that cannot be dry enough to use traditional RUST GRIP® and require a high surface tensile strength. It can be used directly to wet or damp metal surfaces and maintain excellent adhesion to prevent further surface corrosion. It is a water repelling epoxy for use under water or in areas where constant splashing or condensation is a problem. It is resistant to chemicals and solvents, and is designed to be applied directly to concrete, masonry and metal. RUST GRIP-E must be top-coated with to prevent chalking.