RUST GRIP®:

RUST GRIP® is a tough, one-part, moisture-cure polyurethane coating that absorbs atmospheric moisture to cure. RUST GRIP®  is  loaded with a metallic pigment for strength and is also resistant to chemical solvents and acid splash. Upon curing, RUST GRIP® provides a protective coating film of superior adhesion and flexibility, and is resistant to abrasion and impact. RUST GRIP® can be used  as  a primer or as a one-coating system. It is patented to encapsulate lead- based paints and other toxic materials, including asbestos. RUST GRIP® can be applied over pressure- ashed, completely dry flash rust and firmly bonded commercial paints. In most cases, a white or near- white blasting is not required. A light to medium surface rust is preferred as the profile

Moist MetalGrip:

MOIST METAL GRIP is a two-part epoxy coating system that has been specifically designed with specific additives to promote adhesion when used on metal. MOIST METAL GRIP was developed to be applied to metal surfaces that cannot be dry enough to use RUST GRIP®. It can be applied directly to wet or damp metal surfaces and maintain excellent adhesion to prevent further surface corrosion. It is a water repelling epoxy for use under water or in areas where constant splashing or condensation is a problem. It is resistant to chemicals and solvents, and is designed to be applied directly to concrete, masonry and wood

Rustgrip E:

RUST GRIP-E is a two-part epoxy coating system that has been designed with specific additives to promote adhesion when used on metal, and contains metallic pigment used I our regular RUST GRIP®  to strengthen coating and retard chalking. RUST GRIP-E was developed to be applied to metal surfaces that cannot be dry enough to use traditional RUST GRIP® and the surface tensile strength requirements exceed that of Moist Metlagrip. It can be used directly to wet or damp metal surfaces and maintain excellent adhesion to prevent further surface corrosion. It is a water repelling epoxy for use under water or in areas where constant splashing or condensation is a problem. It is resistant to chemicals and solvents, and is designed to be applied directly to concrete, masonry and metal. RUST GRIP-E must be top-coated to prevent chalking